Clarity CLS45i Operations Instructions download pdf (Page 15)

There are six (6) steps involved in setting up

your CLS45i.

1. Install included battery pack into handset.

2. (Optional) Insert four AA alkaline batteries

(for backup in case of AC power outage)

into base.

3. Decide if you want the telephone to sit

on a desk/tabletop or hang on the wall (if

on the wall, follow Instructions for Wall

Mounting)

4. Plug the telephone line cord into the phone

base and telephone wall jack

5. Plug the electrical adapter into a 110-120V

AC wall outlet

6. Place handset in the cradle face up and let

charge overnight or for 10-14 hours

Once your telephone is set up and the

handset is charged, you may proceed to

program up to 17 phone numbers into the

memory speed-dial buttons and set up the

rest of the Special Features.

Installing, Replacing and

Charging the Handset

Battery Pack

Note: the battery pack must be fully charged

before using the CLS-45i

Remove the battery cover on the back of the

handset by pushing the battery compartment

“button” and sliding the cover towards the

bottom of the handset.

1. To install the battery pack, plug the

cord of the battery pack into the terminal

in the battery compartment. Replace the

battery cover by sliding it into place until it

“clicks”.

2. To replace the battery pack, remove the

battery cover as stated above and unplug

the battery from the battery compartment.

Remove old battery pack. Install new battery

pack and plug the cord of the battery pack

into the terminal in the battery compartment.

Replace the battery cover by sliding it into

place until it “clicks”.

Monitoring the Handset

Battery Level

The battery icon will show “full” if there is

an adequate charge level on the battery. As

the phone is used the battery will discharge.

When the handset battery is low the display

will show the battery icon in an “empty”

state, the unit will “beep” every thirty (30)

seconds, and the IN USE/NEW CALL light will

flash. If you are using the phone, the phone

will go dead after approximately two (2) min-

utes. Place the handset back into the base to

recharge the battery.

11

Installing and Using Your CLS45i



















1 2 ... 10 11 12 13 14 15 16 17 18 19 20 ... 107 108

Comments to this Manuals

No comments