Clarity W-1000 User Manual download pdf (Page 5)

Page 5W-1000

The following items are included as part of the CS-03 Requirements.

The Load Number of the equipment is 20.

The standard connecting arrangement code for the equipment is CA11A.

NOTICE: The Canadian Department of Communications label identifies certified

equipment. This certification means that the equipment meets certain telecommunications

network protective operational and safety requirements. The Department does not

guarantee that the equipment will operate to the user’s satisfaction.

Before installing this equipment, users should ensure that it is permissible to be connected

to the facilities of the local telecommunications company. The equipment must also be

installed using an acceptable method of connection. In some cases, the company’s inside

wiring associated with a single line individual service may be extended by means of a

certified connector assembly (telephone extension cord). The customer should be aware

that compliance with the above conditions may not prevent degradation of service in some

situations.

Repairs to certified equipment should be made by an authorized Canadian maintenance

facility designated by the supplier. Any repairs or alterations made by the user to this

equipment, or equipment malfunctions, may give the telecommunications company cause to

request the user disconnect the equipment.

Users should ensure for their own protection that the electrical ground connections of the

power utility, telephone lines and internal metallic water pipe system, if present, are

connected together. This precaution may be particularly important in rural areas.

Caution: Users should not attempt to make such connections themselves, but should

contact the appropriate electric inspection authority, or electrician, as appropriate.

The Load Number (LN) assigned to each terminal device denotes the percentage of total

load to be connected to a telephone loop which is used by the device to prevent

overloading. The termination on a loop may consist of any combination of devices subject

only to the requirement that the total of the load numbers of all the devices does not

exceed 100.

Safety Instructions

Continued

SAVE THESE INSTRUCTIONS

W1000_User_Guide 11/15/99, 9:37 PM5

1 2 3 4 5 6 7 8 9 10 ... 27 28

No comments

Clarity W-1000 User Manual Page 5