Clarity INT9 A/D User's Guide download pdf (Page 14)

Clarity - Getting Started Installation

For easier changing of the wiring we supply

SV8 Terminal board with screw contacts for

INT7 and U-PAD A/D Converters.

Connection of starting cables:

Starting input reacts to a change of the TTL

logical level (5V) or to a connection by any

contact (button, contact of relay).

Input implicitly reacts to a change from HIGH to

LOW (or closing of a contact). The input function

may be changed by switching the Down item of

Ext. Start/Stop section from the

Method Setup -

Measurement

dialog accessible from the Instrument

window using the Method - Measurement

command.

2.3.3 Autosampler

The most typical autosampler connections are

described in chapter 6 on pg. 44.

The autosamplers controlled directly using

an AS Control module (p/n A26) are described

in separate manuals.

2.4 Clarity configuration

Note: Clarity is automatically preconfigured, however it

is recommended to review the following chapter to

assign custom detector names and signal units.

• Start the Clarity station with the

icon on

the desktop.

• Invoke the

System Configuration dialog using the

System – Configuration command.

1 2 ... 9 10 11 12 13 14 15 16 17 18 19 ... 59 60

No comments

Clarity INT9 A/D User's Guide Page 14